Logan,
I agree that, based on the text in H.323, that the Gatekeeper may clearly reject a request due to a lack of needed features and there is no reason code defined to signal such a rejection. Those messages that need this reason include: GRJ, RRJ, ARJ, and LRJ.
The SCR message may also indicate a failure, but there is no "reason" field. For that message, I assume we should add a "neededFeaturedNotSupported" choice under "result".
I'd much rather address this issue before we publish H.225.0v4, rather than afterwards. This clearly appears to be an oversight. Do others have an opinion on this one way or the other?
On a side note, you say that an xRJ may be sent if "the GK does not support those features or cannot find a EP that supports these neededFeatures". I have a question about the latter: was it the intent that the GK would look for a registered endpoint that contains the needed features? I'm not disputing the statement, but I don't believe that's clear in H.323. Also, are the neededFeatures in an ARQ supposed to be propagated via an LRQ when LRQs are used to resolve addresses?
Pete, can you address these last two questions?
Thanks, Paul
----- Original Message ----- From: "Logan Modahala" lmodahal@CISCO.COM To: ITU-SG16@mailbag.cps.intel.com Sent: Wednesday, December 06, 2000 6:00 PM Subject: neededFeaturesNotSupported Reject Reason for RAS missing in H225.0v4
Hi all,
I currently noticed an issue/error with the use of FeatureSet in H225.0v4' RAS messages.
In section 7.9.3.1 Processing by the requesting entity of H323v4 document, there is a statement as follows:
"In response to its request, a requesting entity should either reject a confirm or reject a message".
The neededFeatures field can be filled in RAS messages (RRQ/GRQ/ARQ). If the GK does not support those features or cannot find a EP that supports these neededFeatures from the originator, then I think the only sane thing the GK can do is to Reject (GRJ, RRJ or ARJ) the request with a suitable reject reason value and I guess that is what the above statement is trying to convey.
However, we do not have the appropriate value (neededFeatureNotSupported) rejectReason field of RAS Reject (ARJ, RRJ, GRJ, etc.) messages. We DO HAVE that in the ReleaseComplete H225.0 CallSignaling message for the same purpose. Why is this discrimination?
So, I request the charter to consider this as an oversight/error and recommend the editor to add this value (neededFeatureNotSupported) in the rejectReason field of RAS Reject messages. Otherwise, it will lead to chaos where the Request containing the neededFeatures not being handled appropriately.
-- Logan Modahala lmodahal@cisco.com, logan@cisco.com
For help on this mail list, send "HELP ITU-SG16" in a message to listserv@mailbag.intel.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ For help on this mail list, send "HELP ITU-SG16" in a message to listserv@mailbag.intel.com