CallId/ConfId in LRQ

[Douglas Clowes]

Manoj,

The short answer is that it does *not* work!

Annex G section 1.9 states:

"In many of the examples below, RAS LRQ/LCF messages are shown to be
exchanged between a gatekeeper and a border element within the same
administrative domain. This is for pure illustrative purpose, since the
protocol for reference point B has not been determined (see 1.1)"

It was also accepted in Monterey that the examples do *not* work, for
exactly the reasons you give. The figure added at that meeting (Figure 21)
had the GK and the BE co-located so as not to show the LRQ being used for a
purpose for which it is obviously not suited.

Regards,

Douglas

At 12:12 1999-08-16 -0700, Manoj Paul wrote:
>Hi,
>
>  Presently, when a GK needs to resolve some aliasaddress, it sends
>  LRQ to another GK which has a co-located Border Element (BE). This
>  BE may need to generate an Access Request (according to H.225 Annex G),
>  to another BE. It might be mandatory for the requesting BE to include
>  callInformation (callId/ConfId) in this Access Request (depending on
>  the address template it holds). But LRQ message does not have a callId
>  field in it. How can the requesting BE then derive callInformation for
>  Access Request message?
>  Any help will be appreciated.
>
>  regards
>  Manoj.
>
>