Re: Conflicting text in H.323 concerning the requirement for esta blishing a H.245 control channel??
Fast start sole purpose is to get you talking as fast as possible. It is not to get you inputing digits as fast as possible.
-----Original Message----- From: Agboh, Charles [mailto:charles.agboh@EBONE.COM] Sent: Tuesday, March 20, 2001 7:49 AM To: ITU-SG16@MAILBAG.INTEL.COM Subject: Re: Conflicting text in H.323 concerning the requirement for esta blishing a H.245 control channel??
which defeats the whole point of having a Fast Connect procedure (FS + H.245). Why isn't in-band- DTMF transfer used instead (in FS)?
-Charles
-----Original Message----- From: Frank Derks [mailto:frank.derks@PHILIPS.COM] Sent: Tuesday, March 20, 2001 4:40 PM To: ITU-SG16@MAILBAG.INTEL.COM Subject: Re: Conflicting text in H.323 concerning the
requirement for
establishing a H.245 control channel??
Chris,
I thought I was being clear enough, so let me try again. 6.2.8/H.323 states that an enpoint must open one (and exactly one) H.245 control channel. When Fast Connect is being used, I assume that the intention is that no such control channel is opened.
To be compliant with 6.2.8/H,323 I would have to open a H.245 control channel irrespective of which type of H.245 procedures I will be using. So if I intend to use Fast Start (and assuming that the other party also supports this), I still have to open a H.245 control channel.
Frank
cwp@isdn-comms.co.uk on 20-03-2001 15:17:14 To: Frank Derks/HVS/BE/PHILIPS@EMEA2 cc: ITU-SG16@mailbag.cps.INTEL.COM@SMTP Subject: Re: Conflicting text in H.323 concerning the requirement for establishing a H.245 control channel?? Classification:
Frank,
Why do you consider this text to be "conflicting"? Specifically, with what does it conflict?
Regards, Chris
6.2.8/H.323 states: "The endpoint shall establish exactly
one H.245
Control Channel for each call that the endpoint is
participating in."
8.1.7/H.323 never states that when Fast Connect is being
used such a
control channel should be established. As far as I understand the mechanism this is only required to switch to "normal" H.245
procedures.
It would seem that section 6.2.8 should be rephrased to
make clear that
the H.245 control channel shall only be established when
"normal" H.245
procedures are being followed and not in the fast connect case.
Frank
-- Dr Chris Purvis -- Development Manager ISDN Communications Ltd, The Stable Block, Ronans, Chavey Down Road Winkfield Row, Berkshire. RG42 6LY ENGLAND Phone: +44 1344 899 007 Fax: +44 1344 899 001
> For help on this mail list, send "HELP ITU-SG16" in a message to > listserv@mailbag.intel.com >For help on this mail list, send "HELP ITU-SG16" in a message to listserv@mailbag.intel.com
participants (1)
-
Francois Audet