Venkata,
they could be added as optional parameters to the existing defintions for AMR in H.245 Annex I. AMR is defined as a generic capability, which is extensible. Just make sure that the additional parameters use new identifiers. There should also be some text describing the meaning and usage of the new parameters, and if applicable, their relationship with existing parameters.
This would require sending a delayed contribution to the next SG16 meeting (note the deadline - 4 November 2004 - and the procedural aspects - Paul Jones may be able to advice you). If accepted, the changes could still be edited into the draft for H.245 version 11.
Ernst
-----Original Message----- From: Venkata Nanduri [mailto:vnanduri@cisco.com] Sent: Montag, 18. Oktober 2004 19:18 To: Horvath Ernst Cc: paulej@cisco.com; itu-sg16@external.cisco.com; vdukki@cisco.com Subject: RE: Clarification needed about AMR codec support
Hi,
If that is the case, how those parameters can be negotiated using H245?
Any information in this regard is highly appreciated...
Similar parameters for SIP are defined in RFC3267, Section 8.1.
Thanks Venkata
At 10:01 AM 10/18/2004 -0400, Horvath Ernst wrote:
Venkata,
D-284 was a contribution to the October-2002 meeting of SG16, but Question 3/16 did not accept the proposed text because of conflicts with the existing AMR definitions in H.245. The editor of D-284 was invited to bring a revised proposal to the next meeting, which seemingly did not happen. That's the reason why the parameters proposed in D-284 never became a part of H.245.
Hope this solves your doubts.
Ernst
-----Original Message-----
From: Venkata Nanduri [ mailto:vnanduri@cisco.com mailto:vnanduri@cisco.com ]
Sent: Donnerstag, 14. Oktober 2004 23:41
To: itu-sg16@external.cisco.com
Cc: paulej@cisco.com
Subject: Clarification needed about AMR codec support
Hi,
This email is regarding a clarification needed about a document submitted to SG16(SG 16 - Delayed contribution 284).
In the Document titled "Update on AMR speech codec support for H.245", Table X.4 a parameter "octetAlign"
is mentioned. But the same is missing from the latest H245 formal specification.
As per the document(Delayed contribution 284), "octetAlign" parameter can be used to specify
whether the bandwidth efficient or Octet aligned mode of operation is used.
Since, In the formal spec, this parameter is missing, how should we negotiate whether
we want to use Bandwidth efficient or Octet aligned operation.
I also see other parameters(modeSet, ModeChangePeriod, ModeChangeNeighbour, Crc, robustSorting and interleaving)
mentioned in your document, but are missing from the formal spec.
Any information about how to negotiate those parameters?
Thanks
Venkata