I've done my homework and filled in the references for the Megaco/H.248 requirements document (draft-ietf-megaco-reqs-09.txt) (thanks to those who helped me fill them in):

draft-ietf-megaco-reqs-09.txt references:
13.  References

[1]  S. Bradner, "Key words for use in RFCs to Indicate Requirement Lev-
     els", RFC 2119, March 1997.
[2]  Draft ITU-T Recommendation Q.2630.1, AAL type 2 Signalling Protocol (Capability Set 1), ITU-T Meeting Report COM 11-R 149-E, July 1999

[3]  ITU-T Recommendation H.341, Line Transmission of Non-Telephone Signals, May 1999.
[4]  ATM Forum Technical Committee, af-vtoa-0083.001, Voice and Telephony Over ATM to the Desktop Specification, March 1999.

[5]  ITU-T Recommendatio H.323v2, Packet-based Multimedia Comunications Systems (includes Annex C - H.323 on ATM), February 1998.

[6]  ATM Forum Technical Committee,  af-saa-0124.000, Gateway for H.323 Media Transport Over ATM, May 1999.
[7]  ITU-T Recommendation T.140, Protocol for Multimedia Application Text Conversation, February 1998.
[8]  ITU-T Recommendation V.18, Operational and Interworking Requirements for DCEs Operating in Text Telephone Mode, February 1998.

[9]  ITU-T Q.931, Digital Subscriber Signalling System No. 1 (DSS 1) - ISDN User-Network Interface Layer 3 Specification fro Basic Call Control, March 1993

Nancy
--------------------------------------------------------------------------
Nancy M. Greene
Internet & Service Provider Networks, Nortel Networks
T:514-271-7221 (internal:ESN853-1077) E:ngreene@nortelnetworks.com

----------
From:   Taylor, Tom-PT [CAR:B904-I:EXCH]
Sent:   Friday, December 10, 1999 9:41 AM
To:     ITU-SG16@MAILBAG.INTEL.COM
Subject:        Re: I-D ACTION:draft-ietf-megaco-reqs-09.txt

I propose WG Last Call based on this document, with the expiry two weeks hence (24 December).

Changes from the previous version are as follows:

- removed reqt 5.6 c) Support general test capabilities, for example loopbacks through the MG to test DSP operation.
It was agreed that inward loopbacks are outside the scope of the protocol - they are not part of call control, so would be handled by some other maintenance protocol. Thus the above requirement is deleted.

- reqt 5.7 a) - changed word call to connection

- table in section 11 - removed  wiretap

- reqt 11.1.3.1 a) rewording of 2nd bullet  on addressing - didn't mean wildcarding, meant instead allowing the gateway to choose (part of) the identifier




The references need to be completed still, and there may be an editor's note or two that should still come out.

        -----Original Message-----
From:   Internet-Drafts@IETF.ORG [SMTP:Internet-Drafts@IETF.ORG]
Sent:   Friday, December 10, 1999 8:08 AM
To:     MEGACO@STANDARDS.NORTELNETWORKS.COM
Subject:        I-D ACTION:draft-ietf-megaco-reqs-09.txt

        A New Internet-Draft is available from the on-line Internet-Drafts directories.
This draft is a work item of the Media Gateway Control Working Group of the IETF.

                Title           : Media Gateway control protocol architecture and
                          requirements
        Author(s)       : N. Greene,  M. Ramalho,  B. Rosen
        Filename        : draft-ietf-megaco-reqs-09.txt
        Pages           : 45
        Date            : 09-Dec-99

        TThis document describes protocol requirements for the Media Gateway control protocol between a Media Gateway Controller and a Media Gateway.

        A URL for this Internet-Draft is:
http://www.ietf.org/internet-drafts/draft-ietf-megaco-reqs-09.txt

        Internet-Drafts are also available by anonymous FTP. Login with the username
"anonymous" and a password of your e-mail address. After logging in,
type "cd internet-drafts" and then
        "get draft-ietf-megaco-reqs-09.txt".

        A list of Internet-Drafts directories can be found in
http://www.ietf.org/shadow.html
or ftp://ftp.ietf.org/ietf/1shadow-sites.txt




        Internet-Drafts can also be obtained by e-mail.

        Send a message to:
        mailserv@ietf.org.
In the body type:
        "FILE /internet-drafts/draft-ietf-megaco-reqs-09.txt".

        NOTE:   The mail server at ietf.org can return the document in
        MIME-encoded form by using the "mpack" utility.  To use this
        feature, insert the command "ENCODING mime" before the "FILE"
        command.  To decode the response(s), you will need "munpack" or
        a MIME-compliant mail reader.  Different MIME-compliant mail readers
        exhibit different behavior, especially when dealing with
        "multipart" MIME messages (i.e. documents which have been split
        up into multiple messages), so check your local documentation on
        how to manipulate these messages.




        Below is the data which will enable a MIME compliant mail reader
implementation to automatically retrieve the ASCII version of the
Internet-Draft. << Message:  >>