I propose WG Last Call based on this document, with the expiry two weeks hence (24 December).
Changes from the previous version are as follows:
- removed reqt 5.6 c) Support general test capabilities, for example loopbacks through the MG to test DSP operation. It was agreed that inward loopbacks are outside the scope of the protocol - they are not part of call control, so would be handled by some other maintenance protocol. Thus the above requirement is deleted.
- reqt 5.7 a) - changed word call to connection
- table in section 11 - removed wiretap
- reqt 11.1.3.1 a) rewording of 2nd bullet on addressing - didn't mean wildcarding, meant instead allowing the gateway to choose (part of) the identifier
The references need to be completed still, and there may be an editor's note or two that should still come out.
-----Original Message----- From: Internet-Drafts@IETF.ORG [SMTP:Internet-Drafts@IETF.ORG] Sent: Friday, December 10, 1999 8:08 AM To: MEGACO@STANDARDS.NORTELNETWORKS.COM Subject: I-D ACTION:draft-ietf-megaco-reqs-09.txt
A New Internet-Draft is available from the on-line Internet-Drafts directories. This draft is a work item of the Media Gateway Control Working Group of the IETF.
Title : Media Gateway control protocol architecture and requirements Author(s) : N. Greene, M. Ramalho, B. Rosen Filename : draft-ietf-megaco-reqs-09.txt Pages : 45 Date : 09-Dec-99TThis document describes protocol requirements for the Media Gateway control protocol between a Media Gateway Controller and a Media Gateway.
A URL for this Internet-Draft is: http://www.ietf.org/internet-drafts/draft-ietf-megaco-reqs-09.txt
Internet-Drafts are also available by anonymous FTP. Login with the username "anonymous" and a password of your e-mail address. After logging in, type "cd internet-drafts" and then "get draft-ietf-megaco-reqs-09.txt".
A list of Internet-Drafts directories can be found in http://www.ietf.org/shadow.html or ftp://ftp.ietf.org/ietf/1shadow-sites.txt
Internet-Drafts can also be obtained by e-mail.
Send a message to: mailserv@ietf.org. In the body type: "FILE /internet-drafts/draft-ietf-megaco-reqs-09.txt".
NOTE: The mail server at ietf.org can return the document in MIME-encoded form by using the "mpack" utility. To use this feature, insert the command "ENCODING mime" before the "FILE" command. To decode the response(s), you will need "munpack" or a MIME-compliant mail reader. Different MIME-compliant mail readers exhibit different behavior, especially when dealing with "multipart" MIME messages (i.e. documents which have been split up into multiple messages), so check your local documentation on how to manipulate these messages.
Below is the data which will enable a MIME compliant mail reader implementation to automatically retrieve the ASCII version of the Internet-Draft. << Message: >>